Home / All
Refrigerated air dryer
1,767 products found
Ensure the outlet air quality is good and provide the savings by the energy management system.
Install a dewpoint sensor to monitor the quality of outlet air of dryer and to control the dryer flexible cycle time.
It saves more than 6% of energy than the traditional two-stage thermal control heaters.
SCR thermostat controller to allow the heater to heat up gradually and the service life is extended.
it has excellent heat it has excellent heat conduction.
Heater material is stainless steel or Incoloy. Maximum operating temperature is acceptable to 600~800℃
High closed efficiency to prevent the water vapor contamination from leakage.
Use double eccentric butterfly valve and the position switch to ensure the valve position is correct.
it avoided the dewpoint soike due to moisture penetration as two vessels were switchover.
Cool down the desiccant temperature below 50℃,Factory Price Regenerative air dryer For Textile Industry CE ISO
Use a few CDA to cool the desiccant to avoid the contamination of water vapor and no adsorption in advance.
Procedure of adsorption and regeneration are in reverse direction to ensure there was no repeated adsorption.
This would be able to promote the adsorption efficiency as well as the dewpoint performance at outlet.
The compressor air made the desicccant tight by flowing downstream during adsorption procedure.
change the cycle via PLC controller to allow continuous operation
The function of dewpoint meter is to check the drying quality of the outlet air of dryer
One chamber is operational (drying), while the opposite chamber is regenerating.
Vessel is re-pressurized after the cooling process finished. Now the system is ready for a changeover.
Completion of the heating cycle, use a few drying air to cool down the desiccant bed.
adsorption process is assisted by triggering a blower which suck the ambient air through a heater to regenerate the desiccant.
Dryer contains with twin chambers each filled with desiccant material which dries the compressed air as it passes through.
Pressure Dewpoint -40℃ as standard or -20℃ options are also available.
The compressed air is completely separated providing lowest pressure loss, less desiccant consumption and extend lifetime.
filling is an experiment-proved operation provides best filling rate and distribution of desiccant and erases tunnel effect.
Digital control panel is for easy control and monitoring information by the user.
Optional DDS energy management system, controls dryer cycle times to match plant requirement
Operating with different type of desiccant makes minimum requirement of desiccant
The desiccant is filled by “Snow Storm Filling”, consistent airflow and long desiccant life.
Low installation space and costs Long- life pneumatic cylinder valves provide reliable switching.
Modular construction means less than half the size of traditional dryers.
Sign up for our newsletter to stay up-to-date with our promotions, discounts, sales, and special offers.
subscription
navigation