solutions to your scaffolding needs
service hotline
+86-18366626366
Air Dryer
1,250 products found
Treatment of the air is required before the air can be considered suitable for breathing and certain health.
The air coming from an air compressor, whether lubricated or oil free type, is not suitable for breathing.
These chambers use large volumes of air, which is dried to a low dew point to prevent condensation in the tunnel air stream.
For many years, problems from moisture in air lines were tolerated
The air leaving the aftercooler normally is saturated at the aftercooler discharge temperature
The condensed moisture must be removed by a separator and trap.
Later, as compressed air is discharged and cooled in an aftercooler, condensation begins to occur.
since there is a rise in temperature during actual compression, condensation generally is
avoided within the compressor
avoided within the compressor
Condensation in the compressed air system would occur at the inlet air saturation temperature
Pneumatic Equipment Water-cooled Combined Compressed Air Dryer
Combined air dryer with high quality and efficient heat exchanger and condenser
Lower Air consumption: 3%-5%,Famous air compressor combined compressor air dryer SDZF-25
Lower dew point: -40℃ for normal.-70℃ for special requirement
Timing can be adjusted, the service life of the drier than normal blot machine to extend more than three times.
Stable performance:stable outlet dew point,without any ice block and moisture.
Fully-enclosed refrigeration system with water-removing rate of 90%
High Humidity Alarm: Accurately monitors humidity levels of the compressed air
Dryers are designed for a Maximum Allowable Working Pressure of 1MPa and are provided in 380V-50HZ electrical configuration.
SHANLI heated desiccant dryers include an external heater to heat dry purge air for regeneration.
Moisture Load Control: Reduces purge air consumption by monitoring moisture loading in both towers.
Highly accurate monitoring of dryer dew point performance with an Aluminum Oxide-type
moisture sensor.
moisture sensor.
The use of oil free compressors can reduce the amount of contaminants in a compressed air system.
Before compressed air is used in production, it must be treated to remove moisture and contaminants.
Design features, materials of construction and dimensional data should not be relied upon unless confirmed in writing.
SHANLI reserves the right to incorporate our latest design and material changes without notice or obligation.
At the end of 2 minutes, valve (F) opens and Tower 1 depressurizes. The main air flow is now dried by TOWER 2 .
After a set time, the automatic solid state timer closes purge repressurize valve (D) allowing TOWER 2 to repressurize.
The air is exhausted through purge/repressurization valve (D) and exhaust muffler (E) to atmosphere.
This extremely dry, low pressure air flows through and regenerates the desiccant
in TOWER 2.
in TOWER 2.
Compressed air enters the dryer and is directed to TOWER 1 through valve (A) and exits the dryer through shuttle valve (B).
Sign up for our newsletter to stay up-to-date with our promotions, discounts, sales, and special offers.
subscription
navigation
Email: Click to contact me